AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor
jamesbarnett
Posts: 81
Registered: ‎01-09-2013
Message 1 of 8 (295 Views)
Accepted Solution

Contour Label Directions

295 Views, 7 Replies
12-04-2013 12:14 PM

Is there a way to change the direction of a Label? I want all my text facing the same direction and some of my Labels for contours are turned the wrong direction.



AutoCAD Civil 3D 2014 SP 1
Windows 7 (64)

You can try turning Plan Readable to False in the Label Style.

 

HTH

AWood

Valued Contributor
g_k50
Posts: 68
Registered: ‎03-05-2009
Message 2 of 8 (291 Views)

Re: Contour Label Directions

12-04-2013 12:28 PM in reply to: jamesbarnett

Click on the contour label and move it over a little bit, it might flip upright.

Valued Contributor
jamesbarnett
Posts: 81
Registered: ‎01-09-2013
Message 3 of 8 (288 Views)

Re: Contour Label Directions

12-04-2013 12:35 PM in reply to: g_k50

I tried that. I have to move it to far.



AutoCAD Civil 3D 2014 SP 1
Windows 7 (64)
Mentor
mikehathaway2942
Posts: 257
Registered: ‎10-13-2009
Message 4 of 8 (285 Views)

Re: Contour Label Directions

12-04-2013 12:39 PM in reply to: jamesbarnett
I have never had to do this but if you go into the contour label style editor you can manipulate the settings to achieve the desired results. It may take some trial and error.
Valued Mentor
awood
Posts: 314
Registered: ‎06-24-2005
Message 5 of 8 (281 Views)

Re: Contour Label Directions

12-04-2013 12:50 PM in reply to: jamesbarnett

You can try turning Plan Readable to False in the Label Style.

 

HTH

AWood

Valued Contributor
g_k50
Posts: 68
Registered: ‎03-05-2009
Message 6 of 8 (275 Views)

Re: Contour Label Directions

12-04-2013 12:52 PM in reply to: jamesbarnett

You could rotate your cube until the label flips.

*Expert Elite*
TRogers
Posts: 1,354
Registered: ‎09-05-2007
Message 7 of 8 (262 Views)

Re: Contour Label Directions

12-04-2013 01:26 PM in reply to: jamesbarnett

In your text style under the General tab, change the Readability Bias to 90.

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Valued Contributor
jamesbarnett
Posts: 81
Registered: ‎01-09-2013
Message 8 of 8 (241 Views)

Re: Contour Label Directions

12-04-2013 03:29 PM in reply to: awood

Turning the Plan Readability off fixed my issue.

 

Thanks everyone.



AutoCAD Civil 3D 2014 SP 1
Windows 7 (64)
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.