AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Distinguished Contributor
MonkeyTrainer
Posts: 148
Registered: ‎11-30-2007
Message 11 of 12 (114 Views)

Re: constant slope

10-04-2012 02:17 PM in reply to: Joe-Bouza

ok i found it. i can only get the right side of the assembly. i want to use OW&MS1 is my best fit. how do i do the left side? it wont even let me mirror the thing! its only for the right side!

*Expert Elite*
Joe-Bouza
Posts: 4,964
Registered: ‎12-15-2008
Message 12 of 12 (100 Views)

Re: constant slope

10-04-2012 03:01 PM in reply to: MonkeyTrainer

I highly recommend using OML2 but if you must.

 

the insert point offest + - gets it to the left or right side. study the subassembly help. Its vague but somewhat helpful

 

sample offset =0 = crown point / alignment (profile optional)

insert offset = the +- distance to you saw cut line

 

Here is my warning with this sub assemby: you cannot control the eop with a profile it : widen"Match"Slope thats what it does. Being you have a curbed edge that may or maynot workout for you depending on the existing condition grade.

 

Using the OML2 with a SuprAOR attached gives you flexibility with the eop via profile

Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People) Civil 3D 2012 & 2013
HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram


Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win7 OS
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.