Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
We have a problem where we have a straight pi that runs into a curve pipe. These pipes are not joined with a manhole. We want to show these pipes as on now we can lable only one and edit the labe but it would be better if we could join them using a command like pedit join.
That is good news to hear but our problem is with pipes in the same network.
What we have is from MH-1 to MH-2 a 4m straigh run then a 12m curve then a 80m straight run. what i am looking for is the ability to make this into one pipe from Mh-1 to MH-2
