AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
New Member
EPM09
Posts: 1
Registered: ‎10-28-2012
Message 1 of 2 (610 Views)

Concrete Block Retaining Wall sub assembly

610 Views, 1 Replies
10-28-2012 11:47 PM

I am wondering if anyone has developed a sub assembly that produces a concrete block assembly using 80mm wide by 200mm high by 2000m long shapes with the initinal tie to a new profile and uses a condition where it creates a new block if the height difference between the new profile and the existing surface is is greater than 200mm (the height of a block).

*Expert Elite*
KMercier_C3D
Posts: 255
Registered: ‎12-14-2010
Message 2 of 2 (563 Views)

Re: Concrete Block Retaining Wall sub assembly

11-01-2012 05:36 AM in reply to: EPM09

This old post has a concrete block retaining wall. http://forums.autodesk.com/t5/AutoCAD-Civil-3D/SAC-Marked-Points/m-p/3197982#M162176

Kati Mercier, P.E.

Co-author of "Mastering AutoCAD Civil 3D 2013"
AutoCAD Civil 3D 2013 Certified Professional and AutoCAD 2013 Certified Professional
AU2012 Speaker::: CI3001: Reverse Engineering with Subassembly Composer for AutoCAD Civil 3D
AU2011 Speaker::: CI4252: Create Subassemblies That Think Outside the Box With Subassembly Composer for AutoCAD® Civil 3D®
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.