For anyone that has had an issue using Raster Design inside of Civil 3D and has been subject to your cursor hesitating over cogo points. Here is the fix:
1. open the cui
2. under customizations in All Files select "Rollover Tooltips"
3. in the right-side panel of the cui select Cogo Point
4. Un-Check "Style"
5. ok and close the cui.
You will not have any problems with cursor hangs using Raster Design again.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!