Hello , we found some mistake after ubgrading civil 3d to service pack 1.0 , in coridro section shows only one side material left or right and in table and in material list report is calculated only half section , also in sholder included only sholder material , plzz see screanshot for beter understanding
Solved! Go to Solution.
Solved by Jay_B. Go to Solution.
Sure, plus we have base structures that have superelevated properties differing from the paving. Makes for fun modeling, but a wreck in quantities when you get only one side.
Basically, if C3D cannot give proper quantities why am I still using this?
This was the first thing I wanted to test in 2015... It appears to be working again now in 2015 below with symmetrical Curb material being produced:
i have check a project in 2015 and still find the material issue
Really? What specifically?
I also checked Pave for 2 - 12" symmetrical lanes, it gave the correct areas.
Then I made one of those lanes 20' wide and kept the other at 12', and the total area updated correctly.
i take only the half areas that i take from civil 3d 2013 which gives the correct results
ok
https://copy.com/G2nyTOZMKgBP4Rcb
Hello, wedsizi.
I see you made section view like i want to have. Please, can you send me that cross section in cad form. I use civil 2011.
Regards.
I have use custom subassemblies. Load them into civil 3d after close and restart civil 3d and you will resolve that problem.
You are modeling the road using two Baselines for the centerline, and half-road assemblies.
When I make a Full assembly out of your two half assemblies, and use one Baseline for centerline, it works (red solid hatch are the two Materials I chose).
Can you send me back the model with one baseline?
But if it works with one baseline it’s not a solution.
If you open the same model with two baselines with civil 3d 2013 and rebuilt the corridor, the materials are correct.
And it’s easier for me in such a project to work with two or more baselines.
As models became complex more baseline needed to handle them.
We can agree to disagree on that.... This road model would be a lot easier to deal with by using one assembly with targets.
OK but the fact is that with two baseline the program dont work correct.
Civil 3d 2013 and 2014 without sp1 have not this problem.
Civil 3d 2013 and 2014 without sp1 have not this problem.
Yes, I can confirm that for 2013 now. I don't want to uninstall SP1 on 2014 to test this though.
its a known issue for 2014 sp1.
I don't understand how autodesk people think.
Its a huge bug
Thought maybe, why fix previous versions when 2015 is out for download. Anyone check 2015 corridor behavior? I haven't searched for 2015 bugs just yet.
Is this going to be fixed. Any idea what to do until they fix this problem besides upgrading to civil 3d 2015.
FYI,
This issue has been resolved with the release of 2014 Service Pack 2.