Hello to Everyone,
Topic: Pressure Pipe Network
Background: Civil Engineer, recently started using the pressure networks in Civil 3D 2014
Question: When creating new pressure networks, is there a way to control the Top of Pipe Crown Elevation as you go pipe segment to pipe segment
At this point, I see the insertion elevation that becomes the centerline of the pipes and fittings
After laying out the network, do we have to go through pipe properties to adjust the starting and ending outside crown elevation of each pipe?
Also, if we can adjust the elevation as go, can the invert evelation also be a reference to go by when laying out the pipe
Goal: Complete a large pressure network for a New York City project in the most efficient way
Any wisdom would be appreciated
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.