C3D 2010, Win 7, 64 bit
The client is asking for a table of spot elevations every 20 feet for a 2500' project. They want it at curb lines and center of roadway, as well as the offsets since curb lines vary.
I can use my surface to get the elevations, but I would prefer to use my profile and superelevation in case the surface is wonky or gets changed accidentally.
Any suggestions? I have in the past written expressions, but it was a lot of work and required quite of bit of checking using the surface.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.