C3D 2010, Win 7, 64 bit
The client is asking for a table of spot elevations every 20 feet for a 2500' project. They want it at curb lines and center of roadway, as well as the offsets since curb lines vary.
I can use my surface to get the elevations, but I would prefer to use my profile and superelevation in case the surface is wonky or gets changed accidentally.
Any suggestions? I have in the past written expressions, but it was a lot of work and required quite of bit of checking using the surface.
Access a broad range of knowledge to help get the most out of your products and services.