Your surfaces have nothing defining them and they have been moved, twice. Remove the two moves, add the lines/polylines as breaklines and they show up fine:
Go to the Surface Properties and :
If you uncheck an item the surface will not use it when rebuilt. Once you verify that it's not needed you can right click and remove it.
If you find a response which answers your question, please be sure to accept the actual post which helped you as the solution. This will help future searchers quickly find answers to their own questions. Thanks!
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!