I'm a brand new user so hopefully this is an easy question for some of you.
Given a drawing of 3d polyline topo data i was asked to create a profile view.
I got out a training book and simply followed the instructions given to create a profile view from a surface.
The profile view is blank.
Attached is a screan shot of what I am dealing with.
Thank you all!
Solved! Go to Solution.
Solved! by Jeff_M. See the answer in context.
Your surfaces have nothing defining them and they have been moved, twice. Remove the two moves, add the lines/polylines as breaklines and they show up fine:
Check the profile style.
Check all layers on & thawed.
Check the stations & elevations set for the profile view: if you set them yourself you could be out of range of the surface.
Close program & reopen.
Just a few thoughts.
Credit where credit is due! Give kudos or accept as solution whenever you can.
Thanks I appreciate that unfortunately I'm still at a loss, any further ideas would be hugely appreciated.
What i did do is create a standard surface and allignment to use. I used the create profile from surface comand and stuck to the standard settings. I have been messing around with the settings for quite a while.
I do have surfaces listed in the profiles tab of the view properties.
The elivation I'm using is accurate.
Please let me know if any other ideas come to mind.
Access a broad range of knowledge to help get the most out of your products and services.