Community
Civil 3D Forum
Welcome to Autodesk’s Civil 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Civil 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

“Basic assembly” is not drawn correctly in the section view,

5 REPLIES 5
Reply
Message 1 of 6
JamaL9722060
333 Views, 5 Replies

“Basic assembly” is not drawn correctly in the section view,

“Basic assembly” is not drawn correctly in the section view,

 

In the screenshot below, the “Basic assembly” is not drawn correctly in relation to the existing ground.

 

What might be the reason that it is not closed with the existing ground?

 

Thank you for the help,

 

Best

 

Jamal

 

Clip_186.jpg

 

 

Clip_187.jpg

 

---------------------------
Jamal Numan
5 REPLIES 5
Message 2 of 6
LeafRiders
in reply to: JamaL9722060

To me it looks like a target isn't set properly in your Corridor Properties. Either that or there is a gap in your surface which it doesn't look like is the problem.

Message 3 of 6
mathewkol
in reply to: JamaL9722060

Your surface isn't wide enough at that station.  You're using, say, a 3:1 slope and that slope will not intersect the surface because there is not enough surface.

Matt Kolberg
SolidCAD Professional Services
http://www.solidcad.ca /
Message 4 of 6
JamaL9722060
in reply to: mathewkol

Thank you guys for the answer. This is quite useful.

 

Does this affect the calculations of fill and cut then? What might other consequences be?

---------------------------
Jamal Numan
Message 5 of 6
mathewkol
in reply to: JamaL9722060

It will absolutely affect your volumes because there would be nothing to calculate at that station.  You NEED to make your surface larger in that area.  Either get more survey or make stuff up (fudge).

Matt Kolberg
SolidCAD Professional Services
http://www.solidcad.ca /
Message 6 of 6
JamaL9722060
in reply to: mathewkol

Many thanks for the valuable answers.

 

I tried to modify the slops of the “assembly” but sounds that the “sections” doesn’t repond!

 

Is there a particular way to update them according to the change in the “assembly”?

 

Clip_228.jpg

 

Clip_229.jpg

---------------------------
Jamal Numan

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report