AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

New Member
Posts: 2
Registered: ‎09-21-2012
Message 1 of 2 (379 Views)

Autocad Civil 3D - problem in alignment numeration

379 Views, 1 Replies
09-21-2012 01:51 PM

Hey guys,

I’m new in this fórum and I have a problem with Autocad Civil 3D. I have created an alignment by a polyline, have put arcs and tangents and a Label for identify the number of each Arc and Tangent, as the image shows, but has a section that the numbering is wrong, instead of being 24, 25, 26, 27, 28, 29, 30, 31, became 24, 25, 28, 27, 30, 31 ...

I try change somethings, but aparently the Autocad Civil don’t know how count sometimes, I hope you know a solution of my problem.

And as you should have seen, I don’t speak English a lot… Just in complicated situations. hehe

Thank you.
Mauricio Sibulski

*Expert Elite*
Posts: 2,180
Registered: ‎11-08-2005
Message 2 of 2 (348 Views)

Re: Autocad Civil 3D - problem in alignment numeration

09-22-2012 09:08 AM in reply to: mauricio.sibulski

The label and curve tags are numbered in the order they're created.  You can renumber them to suit your needs.  Check the help files at the link.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.