AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
ejfancett
Posts: 7
Registered: ‎06-06-2010
Message 1 of 6 (628 Views)
Accepted Solution

Assembly Style Marker

628 Views, 5 Replies
10-31-2012 07:18 PM

Anyone know how to turn off the yellow flags.  See the attachment photo.  I click on them and the whole assembly is lit. I am at a loss.  What am I missing?

 

Any help will be appreciated.

 

EJ 

That is part of the LaneSuperElevationAOR subassembly, no need to remove it.  The potential pivot property controls it.

*Expert Elite*
mathewk
Posts: 2,753
Registered: ‎07-09-2003
Message 2 of 6 (621 Views)

Re: Assembly Style Marker

10-31-2012 08:28 PM in reply to: ejfancett

That is part of the LaneSuperElevationAOR subassembly, no need to remove it.  The potential pivot property controls it.

Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
Valued Contributor
wizengr
Posts: 52
Registered: ‎06-19-2011
Message 3 of 6 (596 Views)

Re: Assembly Style Marker

11-01-2012 11:19 AM in reply to: mathewk

I thought the flags can be turned off by opening the Properties Palette, selecting the Assembly and then setting the "Potetial Pivot" option in the Tool Palette to "No".

*Expert Elite*
mathewk
Posts: 2,753
Registered: ‎07-09-2003
Message 4 of 6 (594 Views)

Re: Assembly Style Marker

11-01-2012 11:20 AM in reply to: wizengr

Yes, that's what I meant in my comment [...The potential pivot property controls it....]

Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
Active Member
ejfancett
Posts: 7
Registered: ‎06-06-2010
Message 5 of 6 (564 Views)

Re: Assembly Style Marker

11-02-2012 09:25 AM in reply to: ejfancett

Thanks!  It is on the subassembly properties.  I should of checked there, but since it lit up with the assembly I was confused.

Valued Contributor
Grimes_MG
Posts: 65
Registered: ‎12-19-2008
Message 6 of 6 (240 Views)

Re: Assembly Style Marker

02-28-2014 10:32 AM in reply to: ejfancett

How would you not display and/or not plot the "Potential Pivot" object if your road need one? I am using the assembly as a "typical cross section" in a drawing and the PP object is plotting.

Win7 (x64), EVGA 790i, 8GB RAM, EVGA 8800GT, 250 GB iSSHDD, & RAID 0/1
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.