AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
ejfancett
Posts: 7
Registered: ‎06-06-2010
Message 1 of 6 (648 Views)
Accepted Solution

Assembly Style Marker

648 Views, 5 Replies
10-31-2012 07:18 PM

Anyone know how to turn off the yellow flags.  See the attachment photo.  I click on them and the whole assembly is lit. I am at a loss.  What am I missing?

 

Any help will be appreciated.

 

EJ 

That is part of the LaneSuperElevationAOR subassembly, no need to remove it.  The potential pivot property controls it.

*Expert Elite*
mathewk
Posts: 2,756
Registered: ‎07-09-2003
Message 2 of 6 (641 Views)

Re: Assembly Style Marker

10-31-2012 08:28 PM in reply to: ejfancett

That is part of the LaneSuperElevationAOR subassembly, no need to remove it.  The potential pivot property controls it.

Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
Valued Contributor
wizengr
Posts: 52
Registered: ‎06-19-2011
Message 3 of 6 (616 Views)

Re: Assembly Style Marker

11-01-2012 11:19 AM in reply to: mathewk

I thought the flags can be turned off by opening the Properties Palette, selecting the Assembly and then setting the "Potetial Pivot" option in the Tool Palette to "No".

*Expert Elite*
mathewk
Posts: 2,756
Registered: ‎07-09-2003
Message 4 of 6 (614 Views)

Re: Assembly Style Marker

11-01-2012 11:20 AM in reply to: wizengr

Yes, that's what I meant in my comment [...The potential pivot property controls it....]

Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
Active Member
ejfancett
Posts: 7
Registered: ‎06-06-2010
Message 5 of 6 (584 Views)

Re: Assembly Style Marker

11-02-2012 09:25 AM in reply to: ejfancett

Thanks!  It is on the subassembly properties.  I should of checked there, but since it lit up with the assembly I was confused.

Valued Contributor
Grimes_MG
Posts: 68
Registered: ‎12-19-2008
Message 6 of 6 (260 Views)

Re: Assembly Style Marker

02-28-2014 10:32 AM in reply to: ejfancett

How would you not display and/or not plot the "Potential Pivot" object if your road need one? I am using the assembly as a "typical cross section" in a drawing and the PP object is plotting.

Win7 (x64), EVGA 790i, 8GB RAM, EVGA 8800GT, 250 GB iSSHDD, & RAID 0/1
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.