AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
b1auvt96
Posts: 8
Registered: ‎10-14-2011
Message 1 of 4 (991 Views)

applying superelevation to section view assemblies

991 Views, 3 Replies
10-17-2011 07:05 PM

alignment, profile, assembly and corridor have been setup.  i have setup the superelevation calcuations and did the super elevation view and it looks right, but for some reason the super elevation won't apply to my section view assemblies  or the corridor editor. any ideas?

*Expert Elite*
mathewk
Posts: 2,767
Registered: ‎07-09-2003
Message 2 of 4 (975 Views)

Re: applying superelevation to section view assemblies

10-18-2011 07:49 AM in reply to: b1auvt96

Which version of C3D?

Which subassembly are you using for your lanes?

Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
Mentor
miked
Posts: 164
Registered: ‎12-16-2003
Message 3 of 4 (961 Views)

Re: applying superelevation to section view assemblies

10-18-2011 03:56 PM in reply to: b1auvt96

First off make sure the sub assembly you are using can in fact utilizes superelevation

 

Secondly if the sub assembly can utilize superelevation make sure it is set to use laneinside or similar and not set to none as is some of the sub assemblies by default.

NVIDIA Quadro 600
Civil3D 2012 64x
Active Member
caruga1
Posts: 7
Registered: ‎04-29-2011
Message 4 of 4 (822 Views)

Re: applying superelevation to section view assemblies

05-31-2012 06:04 PM in reply to: b1auvt96

Hi!

I have same issue!

I'm using 2013 ver. of C3D and also have calculated superelevation for undivided planar road with LaneSuperelevationAOR subassamblie.

Superelevation View seems good but can't get it in section view.

 

Subassamby parameters:

                                                                                  L                          R

Use Superelevation :                                     Left Lane Inside       Right Lane Inside 

Slope Direction:                                             Away from Crown     Away from Crown

Potential Pivot :                                                      Yes                            Yes

Outside Point Code:                                              None                          None

 

Assambly is set as Undivided Planar Road...

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!