AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
Scuttlebutt95
Posts: 9
Registered: ‎04-08-2013
Message 1 of 2 (83 Views)

Any way to "reverse lookup" a table tag?

83 Views, 1 Replies
05-10-2014 01:08 PM

I have a drawing (created by someone else) that has multiple sheets.  There is a line table for each sheet that starts with L1 on each sheet - so there are a lot of duplicate tag numbers.  I removed the L1 line from a table (L1 line is not gone, just temporarily hidden as that line may come back).  When I did that I noticed that an L6 line mysteriously appeared in the table.  I don't have any idea what line/tag this L6 is referencing.  Is there any way to find that out?  

 

I already tried to do a quick select for a line matching the distance / bearing shown in the table, but didn't find what I was looking for.  it's possible that the tag is referenced to a polyline or Parcel segment but there isn't an option to select by length of segment.  

 

Any ideas?  

*Expert Elite*
wfberry
Posts: 1,941
Registered: ‎09-05-2006
Message 2 of 2 (77 Views)

Re: Any way to "reverse lookup" a table tag?

05-10-2014 01:34 PM in reply to: Scuttlebutt95

Are you sure that L6 is not the same as the previous L1?

 

 

Bill

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.