AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor
L3GO-Ed
Posts: 61
Registered: ‎11-28-2013
Message 1 of 2 (146 Views)
Accepted Solution

Alignment / Profile Report - Cannot adjust Station Format

146 Views, 1 Replies
04-12-2014 12:40 AM

I recently tried to make station reports for Profiles and Alignments but when I change the Station format i.e, for 673+50 to 67+350, in the tools setting, It stubbornly displays the former in the created CSV. report. Any Ideas???

Have you checked the Station Settings within the Ambient Settings tab for the current Drawing Settings? There is a setting on that tab for Station Delimiter Position.

I have read were the reports do not always follow the report settings and default to the drawing's settings.
Valued Contributor
~Opie
Posts: 58
Registered: ‎04-08-2014
Message 2 of 2 (115 Views)

Re: Alignment / Profile Report - Cannot adjust Station Format

04-14-2014 06:26 AM in reply to: L3GO-Ed
Have you checked the Station Settings within the Ambient Settings tab for the current Drawing Settings? There is a setting on that tab for Station Delimiter Position.

I have read were the reports do not always follow the report settings and default to the drawing's settings.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.