AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Distinguished Contributor
tr4driver
Posts: 125
Registered: ‎12-13-2006
Message 1 of 3 (653 Views)
Accepted Solution

Adding Profile Elevation Info to Alignment Geometry Points

653 Views, 2 Replies
09-22-2010 07:27 AM

Hello...

 

I'm trying to figure out how to add referenced elevation information to the horizontal alignment geometry points.  I've edited the style and added a 'Reference Text' value and then added 'Profile Elevation' to the contents.  My problem is I can't for the life of me figure out how to actually tell it which profile I want to reference so all I get are "???" in the note.

 

When dealing with a single label, it will prompt me for the elevation I want to reference when I place the label, or I can select to the label and edit it's properties to add/change the referenced profile.  With the standard geometry points labels, when I try to select one of them, it selects all of them (which is fine since I want all of them to reference the same profile), but I can't find any way to actually edit/add the profile that I want referenced.

 

Anyone know how to do this?

 

I can always create another label style and add them to each geometry point one at a time, but it just seems like there should be a way to do this with the normal geometry point label style.

 

Thanks in advance for any help/info.

 

Kurt

You must select each label, one at a time, while holding the CTRL key. Then you can set the reference profile via the Properties palette.

*Expert Elite*
Jeff_M
Posts: 4,450
Registered: ‎07-22-2003
Message 2 of 3 (647 Views)

Re: Adding Profile Elevation Info to Alignment Geometry Points

09-22-2010 07:57 AM in reply to: tr4driver

You must select each label, one at a time, while holding the CTRL key. Then you can set the reference profile via the Properties palette.

Jeff_M, also a frequent Swamper
Distinguished Contributor
tr4driver
Posts: 125
Registered: ‎12-13-2006
Message 3 of 3 (644 Views)

Re: Adding Profile Elevation Info to Alignment Geometry Points

09-22-2010 07:59 AM in reply to: Jeff_M

Ahhhh....

 

Thank you!

 

Kurt

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.