Adding a New Surface to an Existing Profile View

[StumpMasterFlex]

I know I should probably know this, but I have not been able to figure it out.  Any help would be appreciated.  

I have an existing profile view that was created with an Existing and Proposed Surface Profile on it.  My engineer has asked me to show the Pre-grade surface also.  However, I never defined a pre-grade surface to the profile view when I created (because the pre-grade was not yet built).

Is there any way to add a new surface to an existing profile?  I have tried numerous times and can't find it.

Kindest Regards

Michael

[Jeff_M · Accepted solution]

Just create the Surface Profile, it will automatically show up in all ProfileViews for that alignment.

[StumpMasterFlex]

I see thank you that worked.  I thought I had to go through Profile View Properties.

Thanks again, have a nice day.