AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor
johnwilson0805
Posts: 50
Registered: ‎07-12-2012
Message 1 of 5 (358 Views)
Accepted Solution

ADD A TURN OUT ALONG A BIKE PATH CORRIDOR

358 Views, 4 Replies
10-29-2012 12:29 PM

I need to add a turnout (not intersection) along a bike path at a given station (see pdf attachment)

if I draw a turnout with nice arcs and lines, is there a way to add it to the corridor with extended

cross slope from the assembly at that point?

 

Thanks

 

John Wilson

yes, it's possible.

You have to use a BasicLaneTransition.

Please use help for better explainance.

Good luck.

Thank you very much. It helped to research edit target to a polyline layout

 

John

While polylines can be used as targets they are static entities, so they don't move if your alignment changes. A better solution is to use offset alignments with widenings. Then you can move the widening along the baseline or edit it parametrically. You want a solution that is dynamic to changes to the design.

 

Also for a widening you should consider using an offset in your assembly so that your template will be perpendicular to the edge of pavement through the widening.

Valued Contributor
bpoleuca
Posts: 61
Registered: ‎03-23-2007
Message 2 of 5 (355 Views)

Re: ADD A TURN OUT ALONG A BIKE PATH CORRIDOR

10-29-2012 12:55 PM in reply to: johnwilson0805

yes, it's possible.

You have to use a BasicLaneTransition.

Please use help for better explainance.

Good luck.

Valued Contributor
johnwilson0805
Posts: 50
Registered: ‎07-12-2012
Message 3 of 5 (330 Views)

Re: ADD A TURN OUT ALONG A BIKE PATH CORRIDOR

10-29-2012 04:48 PM in reply to: bpoleuca

Thank you very much. It helped to research edit target to a polyline layout

 

John

*Expert Elite*
Neilw
Posts: 2,272
Registered: ‎09-04-2006
Message 4 of 5 (318 Views)

Re: ADD A TURN OUT ALONG A BIKE PATH CORRIDOR

10-29-2012 11:45 PM in reply to: johnwilson0805

While polylines can be used as targets they are static entities, so they don't move if your alignment changes. A better solution is to use offset alignments with widenings. Then you can move the widening along the baseline or edit it parametrically. You want a solution that is dynamic to changes to the design.

 

Also for a widening you should consider using an offset in your assembly so that your template will be perpendicular to the edge of pavement through the widening.

Neil Wilson (a.k.a. neilw)
Infrastructure Suite/C3D 2013, LDT 2004, Power Civil v8i SS1
WIN 7 64 PRO
HP Pavillion h8xt, i7 2600, 12 GB
RADEON 6450, 1 GB
http://www.sec-landmgt.com
Valued Contributor
johnwilson0805
Posts: 50
Registered: ‎07-12-2012
Message 5 of 5 (259 Views)

Re: ADD A TURN OUT ALONG A BIKE PATH CORRIDOR

10-31-2012 06:47 AM in reply to: Neilw

Thanks Neil

 

I'll look imto that

 

John

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.