Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I tried to edit the length of a vertical curve in the Profile Grid View Panorama window and the software would not apply the change. I exited Civil 3D and restarted and then the edit worked fine. I ran into some of this behavior where things would stop working until I exited and restarted with C3D 2006 and was kind of hoping this would not occur with 2008. Is there an explanation for this or should I just get used to exiting and restarting when certain things seem to stop working?
-Mark
In this case, I found that closing and re-opening the drawing allowed me to edit a VC length that I couldn't edit before. This is better than completely exiting C3D, but I'm still wondering what's going on.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")