AutoCAD Civil 3D Customization

AutoCAD Civil 3D Customization

Reply
Member
dbrookshire
Posts: 3
Registered: ‎06-21-2006
Message 1 of 2 (405 Views)

Determining Dam Permit Volumes in Civil 3D

405 Views, 1 Replies
06-01-2012 09:27 AM

I am looking to find out if the is a way of generating a stage storage table or volume table showing only the volume in the pond from the lowest intersecting existing ground contour to the top of the pond (to determine what would spill out of the pond in case of a berm failure) and if Civil 3D could make the determination of where that intersecting point is.

 

Thanks,

 

Dave B 

ADN Support Specialist
Partha.Sarkar
Posts: 543
Registered: ‎06-09-2009
Message 2 of 2 (316 Views)

Re: Determining Dam Permit Volumes in Civil 3D

08-03-2012 03:38 AM in reply to: dbrookshire

Hi Dave B,

 

There is no direct way to generating the Volume table, however I think you can achieve this using the GetBoundedVolumes() and ExtractContours() .NET API.

 

You can get some code snippet on GetBoundedVolumes() and ExtractContours() in our Infrastructure DevBlog page (links given below) :

 

http://adndevblog.typepad.com/infrastructure/2012/05/using-surfacegetboundedvolumes-in-autocad-civil...


http://adndevblog.typepad.com/infrastructure/2012/08/extract-surface-contours-using-civil-3d-net-api...

 

Hope this helps.



Partha Sarkar
Developer Technical Services
Autodesk Developer Network

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.