AutoCAD Architecture General Discussion

AutoCAD Architecture General Discussion

Reply
Contributor
jfburton
Posts: 24
Registered: ‎04-06-2006
Message 1 of 1 (98 Views)

Wall Sweep Problem

98 Views, 0 Replies
01-04-2010 08:44 AM
I have a wall with a water table component to which I've attached a sweep. When I insert a door or window assembly that cuts through this component, I end up with a gap between the frame and water table. How do you eliminate this offset/gap between the water table (which has a sweep attached to it) and frames? The gap is the same distance as the chamfer of the water table. If the wall sweep is removed, the gap between the water table and door frame is eliminated. Is there a way to correct this and keep the sweep? I've attached a sample drawing (ACA 2010) showing this condition.

Thanks for any help,

Jim
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.