For one of my users, ACA 2008 only lets him add a wall once per session.
Any subsequent execution of the WallAdd command (whether from the tool
palette, command line, or addselected) just cancels out. No error
message or anything, just:
Command: WallAdd
Start point or [STyle/Group/WIdth/Height/OFfset/Justify/Match/Arc]: *Cancel*
Command:
I did figure out, however, that this only happens when the Properties
palette is closed. If it's open, everything works fine.
Any ideas? I'd rather not install SP1 because of the problems it
creates with the palettes crashing (something to do with AcCamera.arx).