AutoCAD Architecture General Discussion

AutoCAD Architecture General Discussion

Reply
Contributor
terence.duggan1910
Posts: 12
Registered: ‎05-25-2007
Message 1 of 4 (866 Views)

New Bay Window Style

866 Views, 3 Replies
01-03-2010 01:46 AM
Hi
Can anyone tell me the best way to creating a new bay window style.
I need to create my own bay window style, as the out of the box style is not what I am looking for.

Thanks for any help.
*Nathan
Message 2 of 4 (866 Views)

Re: New Bay Window Style

01-03-2010 04:42 PM in reply to: terence.duggan1910
Are we to guess what type you ARE after??
post a .jpg maybe?



wrote in message
news:6311329@discussion.autodesk.com...
Hi
Can anyone tell me the best way to creating a new bay window style.
I need to create my own bay window style, as the out of the box style is not
what I am looking for.

Thanks for any help.
Contributor
terence.duggan1910
Posts: 12
Registered: ‎05-25-2007
Message 3 of 4 (866 Views)

Re: New Bay Window Style

01-06-2010 05:21 AM in reply to: terence.duggan1910
Hi Nathan

Thanks for getting back to me.

I enclose details of the bay window type, and I would like it to be able to change in width & ht.

The centre width to be 915,950,1200mm & the ht to be 1200,1350,1500mm.




Thanks again for any help.
*Nathan
Message 4 of 4 (866 Views)

Re: New Bay Window Style

01-06-2010 08:02 AM in reply to: terence.duggan1910
the content OOTB is not dynamic but you could explode it, stretch etc and
create the ones you want.
If I remember correct that would mean 9 models!
I create mine from scratch and they are individual windows and not
altogether and would need to be altered each one.
Not the answer you were after I'm sure.
I'm sure I've seen this on the wish list before.

If you have some experience with DWA's it might be possible to create one
with windows set at 45d each end as blocks inserted. Height would be
dynamic. Width for the wings would be based on the straight not the 45 and
the block would distort the frame as stretched. You seem to indicate that
width would not change, only the centre width so it should be ok. I don't
know how it would sit in the wall though. Might need to be a CWA instead.

I'd manually create and move on. :-(


wrote in message
news:6313062@discussion.autodesk.com...
Hi Nathan

Thanks for getting back to me.

I enclose details of the bay window type, and I would like it to be able to
change in width & ht.

The centre width to be 915,950,1200mm & the ht to be 1200,1350,1500mm.




Thanks again for any help.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.