AutoCAD 2013/2014/2015

AutoCAD 2013/2014/2015

Reply
Contributor
ronane
Posts: 15
Registered: ‎09-03-2012
Message 1 of 6 (1,734 Views)

Unhandled Access Violation reading 0xffffffff exception at e14572a7h

1734 Views, 5 Replies
02-14-2013 12:06 AM

Hi Everyone,

 

We're trying to elete an object with a constrain on it in ourdrawing. Problem is, when we try to either delete the object or remove the constraint on it, our AutoCAD 2013 crashes with the error in the subject. Additional detail is that the file was created in a lower version, I'm hazy on it but I think it was created on AutoCAD 2011. 

 

Has anyone else encountered this problem? Thanks. :smileyhappy:

*Expert Elite*
rkmcswain
Posts: 3,448
Registered: ‎11-13-2006
Message 2 of 6 (1,718 Views)

Re: Unhandled Access Violation reading 0xffffffff exception at e14572a7h

02-14-2013 04:59 AM in reply to: ronane

Is this a crash you can repeat in any new empty drawing, or does this only happen in a particular drawing?

Contributor
ronane
Posts: 15
Registered: ‎09-03-2012
Message 3 of 6 (1,709 Views)

Re: Unhandled Access Violation reading 0xffffffff exception at e14572a7h

02-14-2013 05:18 PM in reply to: rkmcswain

Hi rkmcswain,

 

The error is only for a specific drawing.

*Expert Elite*
braudpat
Posts: 2,157
Registered: ‎12-15-2006
Message 4 of 6 (1,699 Views)

Re: Unhandled Access Violation reading 0xffffffff exception at e14572a7h

02-14-2013 11:36 PM in reply to: ronane

 

Hello

 

Could you open your DWG in RECOVERY Mode and then Re-Save it ...

 

Have you yet the same problem ?

 

Bye, Patrice

 

Bye, Pat

Contributor
ronane
Posts: 15
Registered: ‎09-03-2012
Message 5 of 6 (1,695 Views)

Re: Unhandled Access Violation reading 0xffffffff exception at e14572a7h

02-14-2013 11:53 PM in reply to: braudpat

Hi Patrice,

 

Thanks for the reply. We can't open it in RECOVER, it just crashes. It just says  "problems were were detected. recommend that you save your work and restart program."

*Expert Elite*
braudpat
Posts: 2,157
Registered: ‎12-15-2006
Message 6 of 6 (1,686 Views)

Re: Unhandled Access Violation reading 0xffffffff exception at e14572a7h

02-15-2013 02:48 AM in reply to: ronane

 

Hello

 

Aie, Aie, your DWG seems very damaged !

 

An other idea : from a blank DWG with correct Units

Try to insert it at 0,0 - Rotation = 0 - Scale = 1 - In exploded mode

 

If OK, please try immediateley an AUDIT

 

Good Luck, Bye, Patrice

 

 

Bye, Pat

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.