AutoCAD 2013/2014/2015

AutoCAD 2013/2014/2015

Reply
Distinguished Contributor
Exmateria
Posts: 215
Registered: ‎11-19-2008
Message 1 of 8 (288 Views)

Possible bug with object angle field

288 Views, 7 Replies
07-28-2012 03:43 AM

Draw a 20° sloped line.

Add an object field to the line, the angle shown is 0.3491 and not 20



*Expert Elite*
dbroad
Posts: 1,646
Registered: ‎08-16-2007
Message 2 of 8 (280 Views)

Re: Possible bug with object angle field

07-28-2012 06:25 AM in reply to: Exmateria

Not a bug. Angles are stored as Radians.  Use the additional format button and add the factor 180/pi  to convert to degrees.  Hint:  Use the system calculator and copy and paste the actual value into the factor field.

Distinguished Contributor
Exmateria
Posts: 215
Registered: ‎11-19-2008
Message 3 of 8 (277 Views)

Re: Possible bug with object angle field

07-28-2012 08:13 AM in reply to: dbroad

This behavior was not the same in previous releases where angles were displayed in the current units. What happen if I open in AutoCAD 2013 an old drawing created in AutoCAD 2012? Is the angle in radians or converted to the currents units?



*Expert Elite*
dbroad
Posts: 1,646
Registered: ‎08-16-2007
Message 4 of 8 (272 Views)

Re: Possible bug with object angle field

07-28-2012 02:02 PM in reply to: Exmateria

I retract my earlier statement.  It is a change and most certainly a bug.  You should report it via autodesk.com/submitbug

Distinguished Contributor
Exmateria
Posts: 215
Registered: ‎11-19-2008
Message 5 of 8 (270 Views)

Re: Possible bug with object angle field

07-28-2012 02:09 PM in reply to: dbroad

Ok, i will do that.



*Expert Elite*
Patchy
Posts: 6,318
Registered: ‎09-16-2009
Message 6 of 8 (235 Views)

Re: Possible bug with object angle field

07-30-2012 07:42 AM in reply to: Exmateria
Valued Contributor
AUGIfr
Posts: 58
Registered: ‎07-28-2012
Message 7 of 8 (223 Views)

Re: Possible bug with object angle field

07-30-2012 09:04 AM in reply to: Patchy

Thanks, has a patch been posted?



*Expert Elite*
Patchy
Posts: 6,318
Registered: ‎09-16-2009
Message 8 of 8 (219 Views)

Re: Possible bug with object angle field

07-30-2012 09:11 AM in reply to: AUGIfr
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.