AutoCAD 2013/2014/2015

AutoCAD 2013/2014/2015

Reply
Distinguished Contributor
Exmateria
Posts: 215
Registered: ‎11-19-2008
Message 1 of 8 (276 Views)

Possible bug with object angle field

276 Views, 7 Replies
07-28-2012 03:43 AM

Draw a 20° sloped line.

Add an object field to the line, the angle shown is 0.3491 and not 20

*Expert Elite*
dbroad
Posts: 1,585
Registered: ‎08-16-2007
Message 2 of 8 (268 Views)

Re: Possible bug with object angle field

07-28-2012 06:25 AM in reply to: Exmateria

Not a bug. Angles are stored as Radians.  Use the additional format button and add the factor 180/pi  to convert to degrees.  Hint:  Use the system calculator and copy and paste the actual value into the factor field.

Distinguished Contributor
Exmateria
Posts: 215
Registered: ‎11-19-2008
Message 3 of 8 (265 Views)

Re: Possible bug with object angle field

07-28-2012 08:13 AM in reply to: dbroad

This behavior was not the same in previous releases where angles were displayed in the current units. What happen if I open in AutoCAD 2013 an old drawing created in AutoCAD 2012? Is the angle in radians or converted to the currents units?

*Expert Elite*
dbroad
Posts: 1,585
Registered: ‎08-16-2007
Message 4 of 8 (260 Views)

Re: Possible bug with object angle field

07-28-2012 02:02 PM in reply to: Exmateria

I retract my earlier statement.  It is a change and most certainly a bug.  You should report it via autodesk.com/submitbug

Distinguished Contributor
Exmateria
Posts: 215
Registered: ‎11-19-2008
Message 5 of 8 (258 Views)

Re: Possible bug with object angle field

07-28-2012 02:09 PM in reply to: dbroad

Ok, i will do that.

*Expert Elite*
Patchy
Posts: 6,267
Registered: ‎09-16-2009
Message 6 of 8 (223 Views)

Re: Possible bug with object angle field

07-30-2012 07:42 AM in reply to: Exmateria
Valued Contributor
AUGIfr
Posts: 57
Registered: ‎07-28-2012
Message 7 of 8 (211 Views)

Re: Possible bug with object angle field

07-30-2012 09:04 AM in reply to: Patchy

Thanks, has a patch been posted?

*Expert Elite*
Patchy
Posts: 6,267
Registered: ‎09-16-2009
Message 8 of 8 (207 Views)

Re: Possible bug with object angle field

07-30-2012 09:11 AM in reply to: AUGIfr
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.