do you have these 2 objects as DWG?
- alfred -
including that errors too?
IMG1, upper issue: Large arcs get small arcs and lines
IMG1: lower issue: Same again, double-arc is converted to straight segment (twice, I marked only one position)
IMG2: upper issue: an arc is converted in a wrong direction (looking like a bumb)
IMG2: lower issue: a segment is missing at all
As long as there are only polylines (not curved or splined, just arcs and streight segments) I would guess such a tool should be done quite fast (as long as you are willing to get no elliptical arcs in the projection). Don't you have other geometry types included like symbols or text? Because that objects are the ones that makes up the work for development.
What do you do with this new geometry then? Is it just used to plot or do you use that within other drawings (or whatever goes on with that geoms)?
- alfred -
Including the errors?? No, not including the errors. You didn't take long to find the reason i'm looking for another way. This is why i'm looking for an app to accomplish this for me, error free. And yes, we would like elliptical arcs/circles. And yes, we would like text to be converted also if possible.
I thought i had seen this mythical app before but i can't find it again. I wouldn't ask anyone to re-create it because i'm fairly possitive it is out there, somewhere.
no elliptical arcs (as in your sample, but free of bugs I think. Only TrueType-Fonts will not work that way I did .. just with plain AutoCAD, no tool necessary for that except ExpressTools!
Look to the attachment.
- alfred -
The main steps are:
Look also to the attached video with higher resolution (any internet-browser or IrfanView or ... it's a flash).
HTH, - alfred -
you are welcome. Glad that I could help
Be careful for any other object-types as I don't know all limitations that came with command _FLATTEN. At least I think you get a lot of objects clean projected going that way.
- alfred -
Nice job Alfred!
I have an alternate method of also doing it, probably not any better, but I have experienced bad results with the flatten command at times.
Rotate the part (not the view) 30° (or what ever you want) in the Y. I used the "rotate3d" command with the "y" option. Rotate again by the same amount in the X. Again, I used the "rotate3d" command with the "x" option. Next, I used the "planesurf" command (surface tab -> Planar) with the "O" option. Select the geometry and a surface will be created. Finally, I used the "Flatshot" command to create a 2D view of the surface.
As for text, you can add that after - in either mine or Alfred's solution - and Truetype fonts will work. First, find the angle of any of the "horizontal" lines ("properties", "list", etc.). Create a new text style (with what ever font you want) and set the oblique angle to match the horizontal line's angle. Create your text. Finally, rotate the text to the same angle used as the oblique angle.
Sorry, no fancy flash
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!