I recently upgraded from AD2 to 2013 Arch....bigggggg change.
All of of my old dimensions needed to be reassociated, ok, nice feature I understand that when I move an object now it will adjust the dimension. (except it doesnt)
Im ok with old dimensions having the error.
However, even the new dimensions I create have the (!) icon and need to be reassociated. If i do reassocate them, the error goes away. If I move the line the dimension is on, the dimension doesn't update.
I did some reading on here about associative dimensions. I discovered the DIMASSOC command and set to 0. the (!) icon doesn't appear, but now I get a prompt to verify the dimension value for every dimension I create.
Solved! Go to Solution.
Solved! by Janet2009. See the answer in context.
DIMASOC to 0?
Why not 2?
I have LT 2014
I am having the same issue described in luedersjason's post.
I went to DIMASSOC and it was set to 2 already?
And I have a RED + sign on the ANNOTATION MONITOR, however I cannot turn it to white or change its "state"?
Any thoughts? or suggestions?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!