I am trying to create a leader that reads the block "name" and then places it into circle, or square at the end of a leader.
I see it in the "other" programs but I have plain ole Autocad.
Should be simple enought except my brain is locked in the clouds and im spinning around in circles.
Which may not be a bad thing, except NASCAR hasnt started yet
Can somebody point me general direction on how to get this accomplished
You can add an object field and put a rectangle and leader to it. In order to have the field, a leader, and an enclosing object in AutoCAD, you would need to create a custom command.
AutoCAD Architecture (and other verticals) has this tagging feature built-in.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!