If I have multiple polyline lines that are all on one layer, how would I easily choose only those with elevations in mulitples of five? Basically I need to select all polylines with elevations 125, 130, 135, ect.
I am using the filter command with the ** Begin AND / ** End AND filter, but everything in between seems like there should be a way to simplify it rather than putting in every single elevation I want.
I notice there are operators, and I've used them many times before, but for the life of me I can't figure out how to use the asterisk. Is it used similar to a wildcard? I was thinking that if I chose the asterisk and put in 5, it would choose any polyline ending with an elevation of 5. This doesn't seem to be the case, in fact it just selects every line I choose in the filter selection.
Archie Dodge
Applications Expert - Infrastructure Solutions Division
IMAGINiT Technologies
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")
