Has any one experianced this fatal error during an auto save? If so is there a solution? Any help would ge greatly appreciated!
Have you tried to recover your DWG ?
Have you found a solution to this problem? I am going through the same thing and i have tried to repair, unistall and reinstall.
I tried a lot of things, but the only thing that worked was to start a new drawing and copy over each layer of the orginal drawing seperately, saving after each copy, when it crashed after saving i deleted the element that was causing the fatal error.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!