Community
AutoCAD Forum
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

AutoCAD2014 SP 1 Update installed, and now no manually entering dimensions

5 REPLIES 5
SOLVED
Reply
Message 1 of 6
AndrewS_MBI
541 Views, 5 Replies

AutoCAD2014 SP 1 Update installed, and now no manually entering dimensions

I just updated to AutoCAD 2014 Service Pack 1.  Now when creating solids, I don't see the options of manually entering the dimensions.  Is there a setting somewhere that needs to be switched back on?

5 REPLIES 5
Message 2 of 6
nestly2
in reply to: AndrewS_MBI

Welcome to the AutoCAD forums.

 

Can you be more specific about what command you're using, what happened previously when you used the command compared to what's happening now?

Message 3 of 6
AndrewS_MBI
in reply to: AndrewS_MBI

When using the toolbar, selecting any of the solid objects on the Solid tab would give me the option of selecting the center point, x and y dimensions (radius for sphere, cylinders, etc.), and height.  The options appeared sequentially as tool-tip-like prompts once I clicked in the drawing window.

Message 4 of 6
nestly2
in reply to: AndrewS_MBI

Is Dynamic Input turned on? (status bar toggle or F12)

 

dynmode.jpg

Message 5 of 6
sthompson1021
in reply to: AndrewS_MBI

You have got your dynamic input turned off is what you are describing.

Message 6 of 6
AndrewS_MBI
in reply to: nestly2

Nestly and Sthompson1021, that was it exactly. I knew it was something small and stupid I was missing.

 

Thank you both!

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost