AutoCAD 2013/2014/2015

Reply
Active Member
nicole.ravasini421
Posts: 7
Registered: ‎10-05-2012
Message 1 of 9 (479 Views)
Accepted Solution

3D trim newbie! help!

479 Views, 8 Replies
10-05-2012 08:41 AM

Hi! i'm a Autocad 3D newbie! Have some problems to figure out how to trim a solid from a sphere. well here's an image that will explain better!( it's the pink part from the green) 
thank you so much !

Subtract command.

*Expert Elite*
Patchy
Posts: 6,276
Registered: ‎09-16-2009
Message 2 of 9 (474 Views)

Re: 3D trim newbie! help!

10-05-2012 08:44 AM in reply to: nicole.ravasini421

Trim doesn't work, use SUBTRACT

Active Member
nicole.ravasini421
Posts: 7
Registered: ‎10-05-2012
Message 3 of 9 (472 Views)

Re: 3D trim newbie! help!

10-05-2012 08:45 AM in reply to: Patchy

the subtract command subtracts the whole pink solid and leaves the empty shape in the sphere, I just need to cut the part that sticks out from the bottom of the sphere! 

*Expert Elite*
Patchy
Posts: 6,276
Registered: ‎09-16-2009
Message 4 of 9 (463 Views)

Re: 3D trim newbie! help!

10-05-2012 08:52 AM in reply to: nicole.ravasini421

Attach your drawing here.

Active Member
nicole.ravasini421
Posts: 7
Registered: ‎10-05-2012
Message 5 of 9 (461 Views)

Re: 3D trim newbie! help!

10-05-2012 08:55 AM in reply to: Patchy
 
*Expert Elite*
Patchy
Posts: 6,276
Registered: ‎09-16-2009
Message 6 of 9 (447 Views)

Re: 3D trim newbie! help!

10-05-2012 09:56 AM in reply to: nicole.ravasini421

Subtract command.

Active Member
nicole.ravasini421
Posts: 7
Registered: ‎10-05-2012
Message 7 of 9 (442 Views)

Re: 3D trim newbie! help!

10-05-2012 10:05 AM in reply to: Patchy

thanks!! 
but how did u do it? subtract and?

 

*Expert Elite*
Patchy
Posts: 6,276
Registered: ‎09-16-2009
Message 8 of 9 (439 Views)

Re: 3D trim newbie! help!

10-05-2012 10:15 AM in reply to: nicole.ravasini421

Thanks for the challenge, it was not as EZ as I thought.

I had to make a copy of the model, SUBTRACT the unwanted parts, then SEPARATE them, after that I move them back to the original position.

Active Member
nicole.ravasini421
Posts: 7
Registered: ‎10-05-2012
Message 9 of 9 (423 Views)

Re: 3D trim newbie! help!

10-05-2012 12:03 PM in reply to: Patchy

Thank you!!! gonna try to repeat it myself, gotta learn!!!!
thanks again! 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.