In paperspace I set the viewport scale to 1-1/2"=1'-0" on a ANSI D-size plot. But when plotted at (layout) 1:1, it comes out to be 1/8"=1'-0" on a engineering scale.
Can anyone explain Autodesk's logic?
Enter the command SCALELISTEDIT to see what the values are for 1 1/2" = 1'-0". It should say Paper Inches = 1.5, and Drawing Feet = 12, OR... it can also say Paper Inches = 1, and Drawing Feet = 8
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!