AutoCAD 2010/2011/2012

AutoCAD 2010/2011/2012

Reply
Distinguished Contributor
manamalewis
Posts: 131
Registered: ‎11-07-2012
Message 1 of 2 (289 Views)

Terminal Attributes in Autocad Electrical

289 Views, 1 Replies
11-07-2012 11:27 AM

I have a terminal from Phoenix Contact(their p/n 3031429) it's a 2 level terminal - sttb4.  When I associate two terminals (one on the top points, and one for the bottom points), it ends up putting the wrong terminal number on the top line.  It does not matter what order i click as "master terminal" or not.  And When I am dealing with a PLC, I use multiple 2-highs and it is a pain to constantly go in and manually force it to switch.  I will always have one terminal with the wire number(based on rung number) and one based off from a PLC address. Is there a way when associating these terminals it will alway look at the PLC address as the top point?  . . . Hope this makes sense.

 

Thanks

*Pro
ampster
Posts: 1,386
Registered: ‎07-26-2005
Message 2 of 2 (278 Views)

Re: Terminal Attributes in Autocad Electrical

11-07-2012 01:29 PM in reply to: manamalewis

might have better luck over in the AutoCAD Electrical forum;

 

http://forums.autodesk.com/t5/AutoCAD-Electrical/bd-p/38

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.