Hello, New to the message board, but I am a student studing Mechanical Engineering. I am struggling with MMC, LMC, Tolarance, Allowance. and using plus-minus, single limit, limit dimensions. I am using 2012 AutoCad. If anyone knows a place online that can better describe these, and help me with using them on drawings that would be wonderful.
I am struggling with MMC, LMC, Tolarance, Allowance. and using plus-minus, single limit, limit dimensions.
For the dimensions you will create different dim styles for each of those that you listed, you might need several of each.
Use Tolerance command for the actual Feature Control Frame.
For Datums create one in Mulitleaders, that is what I have done.
For understanding GD&T without specific questions it is too wide open to help you.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!