AutoCAD 2010/2011/2012

Reply
*Expert Elite*
Patchy
Posts: 6,273
Registered: ‎09-16-2009
Message 1 of 7 (7,151 Views)

Show circle center mark

7151 Views, 6 Replies
04-21-2011 11:45 AM

Is there an option to show center mark of a circle?

*Expert Elite*
GrantsPirate
Posts: 1,629
Registered: ‎08-15-2008
Message 2 of 7 (7,145 Views)

Re: Show circle center mark

04-21-2011 11:59 AM in reply to: Patchy

ddim, edit a style, Symbols and Arrows tab, Center marks...

----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
*Expert Elite*
Patchy
Posts: 6,273
Registered: ‎09-16-2009
Message 3 of 7 (7,141 Views)

Re: Show circle center mark

04-21-2011 12:05 PM in reply to: GrantsPirate

Thanks, that's thru dimstyle, correct? I need to show centermark for circle after it's drawn (this 102 degrees flu makes me so dizzy)

 

*Expert Elite*
GrantsPirate
Posts: 1,629
Registered: ‎08-15-2008
Message 4 of 7 (7,138 Views)

Re: Show circle center mark

04-21-2011 12:09 PM in reply to: Patchy

draw the circle, dimcenter, pick circle.

----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
*Expert Elite*
Patchy
Posts: 6,273
Registered: ‎09-16-2009
Message 5 of 7 (7,136 Views)

Re: Show circle center mark

04-21-2011 12:10 PM in reply to: GrantsPirate

I got it now. Thanks a bunch.

Member
keerthivasan.910
Posts: 4
Registered: ‎11-22-2013
Message 6 of 7 (3,577 Views)

Re: Show circle center mark

11-22-2013 02:04 PM in reply to: GrantsPirate

Hi,

I tried "dimcenter" and I was able to get the center mark. But the size of the center mark was too small. I tried changing its size in Modify Dimension Properties. But the new size only applies to the new center mark that I create afterwards. The existing center mark remained in the same size. Also, after changing the size, when I select the center mark the Dimension Style option freezes. Can you please help me in this ?

Thank you.

*Expert Elite*
Patchy
Posts: 6,273
Registered: ‎09-16-2009
Message 7 of 7 (3,569 Views)

Re: Show circle center mark

11-22-2013 02:22 PM in reply to: keerthivasan.910
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.