AutoCAD 2010/2011/2012

AutoCAD 2010/2011/2012

Reply
Member
Central_Standard
Posts: 5
Registered: ‎08-25-2012
Message 1 of 2 (245 Views)

Quick Access Toolbar Customization

245 Views, 1 Replies
02-13-2013 10:01 AM

Hello,

 

I added the Layer group (On/Off Frreze Lock/ Unloack and Layer name) to the Quick Acess Toolbar. I only see the first part name of the layer. Is there a way to stretch this part of the group in the QAT tool bar so I can see the more of the layer name? Consensus of mny co-workers is no. 

 

I'm at a new job so perhaps the partial name and layer color may be a sufficient clue as to the whole layer name over time. Would be nice to see the whole name until then.

 

Thanks!

 

C/S

Many men go fishing all their lives without knowing it is not fish they are after.
Mentor
doben
Posts: 171
Registered: ‎06-09-2007
Message 2 of 2 (220 Views)

Re: Quick Access Toolbar Customization

02-15-2013 05:34 AM in reply to: Central_Standard

Open the CUI (type "CUI") and change the minimum width as shown on the attached.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.