AutoCAD 2010/2011/2012

AutoCAD 2010/2011/2012

New Member
Posts: 1
Registered: ‎04-25-2012
Message 1 of 2 (277 Views)

Linking Data to Autocad from UltraPIPE

277 Views, 1 Replies
04-25-2012 06:53 AM

I don't know if anyone else on these boards is familiar with this, but I'm looking for a way to link the whole Equip/Circ ID in a table form instead of by individual datapoints.  Even if I could place the point on the drawing without the TML letter/number I could set it up the way I want.  Thanks in advance.

Posts: 4
Registered: ‎10-18-2010
Message 2 of 2 (203 Views)

Re: Linking Data to Autocad from UltraPIPE

08-31-2012 12:11 PM in reply to: xanidus

That would be handled in the kbupdate.lsp file.  You're looking at some heavy programming there.  That might be costly. 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.