AutoCAD 2010/2011/2012

AutoCAD 2010/2011/2012

Reply
Valued Mentor
392 Posts
16 Kudos
Registered: ‎09-25-2008
Post 1 of 5
Accepted Solution

Layer Control" display

287 Views, 4 Replies
01-31-2013 07:18 AM

At the top of my screen, I have the "Layer Control".

Until this week, if I clicked on a line, the layer the line is on is diplayed in the "Layer Control".

If I wanted to know which layer an item is on, I just click on it and its layer would be displaye.

If I wanted to change the layer an item is on, I just click on it, then go to the "Layer Control", scroll thru the list, click on the layer I want.

This week, the "Layer Control" just shows the Current Layer.

Did I change a setting?

Read Ya Later -KLYPH

Maybe your PICKFIRST is set at ZERO, try 1.

*Expert Elite*
6,429 Posts
601 Kudos
Registered: ‎09-16-2009
Post 2 of 5

Re: Layer Control" display

01-31-2013 07:20 AM in reply to: KLYPHY

Maybe your PICKFIRST is set at ZERO, try 1.

Valued Mentor
392 Posts
16 Kudos
Registered: ‎09-25-2008
Post 3 of 5

Re: Layer Control" display

01-31-2013 07:39 AM in reply to: Patchy

That was it. I normally have is set to "1", but somehow it became set to "0".

Thanks. Read Ya Later -KLYPH

*Expert Elite*
2,461 Posts
263 Kudos
Registered: ‎12-15-2006
Post 4 of 5

Re: Layer Control" display

01-31-2013 07:51 AM in reply to: KLYPHY

Hello

 

Just an idea ...

Command: LAYER

Then in the left part (Filters) of the Layers dialog box, please check that you are displaying ALL Layers

Close

Is it ok ?

 

Bye, Patrice

 

 

Bye, Pat ( Supporting Troops )
If you are happy with my answer please mark "Accept as Solution" and if very happy please give me a Kudos (Compliment) - Thanks
*Expert Elite*
5,760 Posts
502 Kudos
Registered: ‎10-12-2006
Post 5 of 5

Re: Layer Control" display

01-31-2013 03:23 PM in reply to: KLYPHY

Chances are you have some customization or third-party additions present with either no or very basic error handling.  When a tool is called it changes the system variable temporarily, does its work, then (if all goes well) restores the previous value.  If it errors out part way through it doesn't restore the previous setting and you're left holding the empty bag.  If you've ever had the FILEDIA issue, its the same priniciple.

----------------------------------
If you are going to fly by the seat of your pants, expect friction burns.
Adopt. Adapt. Overcome. Or be overcome.
A good question will be halfway to a good answer.


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!