AutoCAD 2010/2011/2012

AutoCAD 2010/2011/2012

Reply
Distinguished Contributor
kameron1967
Posts: 174
Registered: ‎09-05-2008
Message 1 of 2 (674 Views)
Accepted Solution

How to widen the layer pull down dialogue box to show long layer name

674 Views, 1 Replies
12-11-2012 09:23 AM

Hi,

 

I'm curious if anybody had an issue with the layer dialogue box showing not enough layer name.  Is it possible to widen it or is that controlled somewhere?  Thanks in advance.

Figured it out.  I went into the customize user interface (right-click on toolbar).  I added the Layer Combo control onto the quick access tool bar.  I then select the layer combo control and change the display on right side under properties to 350 (Minimum Width).  This layer allows me to pull down and choose any layer to make it current (a limiting option when in Autocad class mode).  Cheers! :smileyhappy:

Distinguished Contributor
kameron1967
Posts: 174
Registered: ‎09-05-2008
Message 2 of 2 (665 Views)

Re: How to widen the layer pull down dialogue box to show long layer name

12-11-2012 09:41 AM in reply to: kameron1967

Figured it out.  I went into the customize user interface (right-click on toolbar).  I added the Layer Combo control onto the quick access tool bar.  I then select the layer combo control and change the display on right side under properties to 350 (Minimum Width).  This layer allows me to pull down and choose any layer to make it current (a limiting option when in Autocad class mode).  Cheers! :smileyhappy:

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.