Heyy there, I just wanna ask about extruding..
I created a plan (2D) then I extruded it (3D), But I am having a problem, I have a ramp, so the first edge should be at level 0, and the 2nd edge is at level 3m. How can I extrude gradually ?
draw the section for the ramp-start at it's position (and it's elevation), do the same for the ramp-end and then use command _LOFT (>>>details<<<).
- alfred -
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!