AutoCAD 2010/2011/2012

AutoCAD 2010/2011/2012

Reply
New Member
exhibits
Posts: 2
Registered: ‎04-26-2012
Message 1 of 3 (1,127 Views)

HELP! Annotation Problem

1127 Views, 2 Replies
04-26-2012 01:48 PM

Hello all, This is likely a really easy fix, but I am struggling with it.

I have an exhibit cabinet that I have layed out for fabrication, and I cannot associate dimensions with the z axis. Autocad will allow me to assocaite dimensions on the x and y axis, but is constrained on the z axis so that I cannot show a vertical dimenstion. The dimension commands will only allow me to show dimensions on the 2-d drawing plane.

 

The drawing was originally created as 2-d lines and then extruded to the desired height. To determine if it was releated to the specific drawing or not, I exited the program and started a new drawing. I created a 2-d box and a cube, using the "box" command under 3-d basics. I had the same problem with the new drawing, so this suggests to me that I somehow managed to change a global setting on the program itself

 

I would really appreciate any help you can provide!

 

Thank you!

*Expert Elite*
GrantsPirate
Posts: 1,648
Registered: ‎08-15-2008
Message 2 of 3 (1,117 Views)

Re: HELP! Annotation Problem

04-26-2012 03:56 PM in reply to: exhibits

You must reorient the UCS, dims only work in XY plane.  You can drag the UCS to where you want it or use UCS, 3point, etc.

 

Also see http://cadtips.cadalyst.com/create-dimension/dimension-3d

----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
New Member
exhibits
Posts: 2
Registered: ‎04-26-2012
Message 3 of 3 (1,113 Views)

Re: HELP! Annotation Problem

04-26-2012 04:07 PM in reply to: exhibits

Ahhh, I see! That worked perfectly- you're a lifesaver! Thank you so much for your quick response!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.