AutoCAD 2010/2011/2012

Reply
*elenist
Message 1 of 5 (1,453 Views)

hatch - layer

1453 Views, 4 Replies
05-18-2010 01:16 AM
I noticed that after I hatch an area using match properties, the new hatch
uses the source layer and that is very good.

But after that, if I hatch another area and change the pattern, the new
hatch is created in the previous used layer instead of the current layer,
and that is very bad.

Can this change?
Valued Mentor
TrevN
Posts: 548
Registered: ‎04-14-2008
Message 2 of 5 (1,453 Views)

Re: hatch - layer

05-18-2010 03:35 AM in reply to: *elenist
With one hand they take, with the other they snatch!

Pun very hatch intended!!
*Dean Saadallah
Message 3 of 5 (1,453 Views)

Re: hatch - layer

05-18-2010 04:50 AM in reply to: *elenist
Keep track of your HPLAYER variable:
http://docs.autodesk.com/ACD/2011/ENU/filesACR/WS73099cc142f487557bfaa8da122ec01152f524a.htm

--
Dean Saadallah
http://LTisACAD.blogspot.com
--
*elenist
Message 4 of 5 (1,453 Views)

Re: hatch - layer

05-18-2010 05:48 AM in reply to: *elenist
The problem is that after you hatch an area using the match properties (in
hatch command) the HPLAYER variable changes to the layer of the hatch
previous selected, even if you change the pattern. In my opinion it should
change to the default value, i.e. the current layer


"Dean Saadallah" wrote in message
news:6392858@discussion.autodesk.com...
Keep track of your HPLAYER variable:
http://docs.autodesk.com/ACD/2011/ENU/filesACR/WS73099cc142f487557bfaa8da122ec01152f524a.htm

--
Dean Saadallah
http://LTisACAD.blogspot.com
--
*Dean Saadallah
Message 5 of 5 (1,453 Views)

Re: hatch - layer

05-18-2010 05:56 AM in reply to: *elenist
A lot of things "should" in this release :smileyhappy:

You have to keep an eye on the ribbon, destination layer is always listed.

--
Dean Saadallah
http://LTisACAD.blogspot.com
--
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.