An example of what i want to do is:
I want to place this typr of coordinate at any spot on the drawing. is there a command that can be invoked?
I'm trying to do the same thing with as-buit drawings. I want each point to show those three attributes, which have been shot in with surveying equipment. I could not use the block given, and it seemed to be for labeling only.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!