AutoCAD 2010/2011/2012

Reply
New Member
renee2
Posts: 1
Registered: ‎06-21-2011
Message 1 of 3 (1,060 Views)

DIMENSIONS TEXT SIZE

1060 Views, 2 Replies
06-21-2011 08:58 PM

MY UNITS ARE IN ARCHITECTURAL, WHICH THEY ARE SUPPOSED TO BE, BUT MY DIMENSIONS COME OUT AS DECIMAL AND THE TEXT SIZE IS REALLY SMALL, EVEN WHEN I PUT THEM AT THE SIZE I WAS RECOMMENDED TO USE THEY ARE SMALL. WHEN I PRINT, THE SIZE IS UNREADABLE ITS A LITTLE DOT. HOW DO I FIX THIS?

*Expert Elite*
Patchy
Posts: 6,267
Registered: ‎09-16-2009
Message 2 of 3 (1,056 Views)

Re: DIMENSIONS TEXT SIZE

06-21-2011 09:17 PM in reply to: renee2

command DIMSTYLE, Primary Units, change Unit Format.

Text too small ?read about Annotative text for dimension style.

*Expert Elite*
GrantsPirate
Posts: 1,626
Registered: ‎08-15-2008
Message 3 of 3 (1,015 Views)

Re: DIMENSIONS TEXT SIZE

06-22-2011 07:53 AM in reply to: renee2

For the text style being used in the dimension, go to Style, pick that text style, set the height to zero, even if it says 0 swipe over and type in a 0.

----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.