AutoCAD 2010/2011/2012

Reply
Member
ouliwei
Posts: 3
Registered: ‎10-03-2012
Message 1 of 5 (518 Views)

Cursor disappearing

518 Views, 4 Replies
10-03-2012 04:20 PM

At no specific time when using ACAD 2012 MEP the cursor disappears.  cross hairs and all.  the only way to get them back is to close ACAD and open it back up.  Very irritating.  any solutions for this?

 

*Expert Elite*
Alfred.NESWADBA
Posts: 9,250
Registered: ‎06-29-2007
Message 2 of 5 (507 Views)

Re: Cursor disappearing

10-03-2012 11:23 PM in reply to: ouliwei

Hi,

 

what graphiccard do you have? And have you tried to disable the hardware acceleration (command _3DCONFIG ==> Manual tune)?

 

- alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
*Expert Elite*
pendean
Posts: 23,016
Registered: ‎11-06-2003
Message 3 of 5 (494 Views)

Re: Cursor disappearing

10-04-2012 05:53 AM in reply to: ouliwei

In addition to all the other advice, is your 2012 MEP fully updated and patched too?

Also check the Autodesk Supported Graphics Cards List and drivers and see if your Vid card is listed and a driver is available for it:
http://www.autodesk.com/autocad-graphicscard

Dean Saadallah Blog | Facebook | Google+ | Twitter | PINS
Member
ouliwei
Posts: 3
Registered: ‎10-03-2012
Message 4 of 5 (483 Views)

Re: Cursor disappearing

10-04-2012 09:43 AM in reply to: Alfred.NESWADBA

the graphic card is an NVIDIA Quadro 610 which was on the cert list when we ordered it 5 months ago.

*Expert Elite*
Alfred.NESWADBA
Posts: 9,250
Registered: ‎06-29-2007
Message 5 of 5 (469 Views)

Re: Cursor disappearing

10-04-2012 12:34 PM in reply to: ouliwei

Hi,

 

>> the graphic card is an NVIDIA Quadro 610

That only answers one question, the other question was:

  • have you tried to disable the hardware acceleration

 

- alfred -

 

 

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.